![]() I looked around a bit more and found a post on another forum where someone had no boot options at all (not related to an upgrade).Next, I deleted HFSPlus.efi and tried installing with just VBoxHfs.efi.This did not work, same issue as original post - everything appears to work, but no special boot option after restart. Delete VBoxHfs.efi and try installing MacOS Big Sur with just HFSPlus.efi (of the two) installed.After looking around, I found t his post by pastrychef which seemed to confirm that only one is needed. Your post seemed to imply that only one of them is needed. It turns out that I had both HFSPlus.efi and VBoxHfs.efi installed. UEFI Drivers (EFI/CLOVER/drivers/UEFI/*): I'm using the following UEFI drivers and kexts. I don't believe this has any significance here, as everything has worked with macOS 10.15.3 and 10.15.7 since this change. As part of my clover update (#2 above), I had to remove FwRuntimeServices.efi in favor of OpenRuntime.efi.I'm using "iMac19,1" system definition and have been successfully for 18 months or so.I'm trying to use the v11.4 of the Big Sur installer and am currently on macOS 10.15.7 using Clover r5138.Everything boots properly and the clover boot menu loads without issue. I don't see any errors or any other indication that something isn't working. Again, I return to the Big Sur update guide, but have the same issue with step 5 - there's no "Boot MacOS Install" option after installation prompts a restart.I'm now successfully running MacOS 10.15.7 with the latest clover, r5138, without issue. After reboot, I do see the appropriate install option and can successfully move through the update to 10.15.7. ![]() I instead moved through the list, but with the update to 10.15.7 instead of Big Sur.I've hidden some options from the list there, but even after using F3 to show all hidden options, the option isn't there. After the reboot at the end of step 4, there is no "Boot MacOS Install" (or similar) option on my clover boot screen. I then moved through the update guide successfully until step 5.This allowed me to successfully boot and run 10.15.3 with clover r5138. I ran into issues booting, but resolved them by updating all my UEFI drivers and kexts to the latest versions and some ist updates derived from this post. I updated my clover from 2.5k_r5104 to r5138.I've used this configuration with Catalina successfully for 12+ months or so? I've completed steps 1-4, but I see no "Boot MacOS Install from Macintosh HD" (or similar) option in the clover boot menu after the forced restart at the end of step 4. I'm following the Update Directly to macOs Big Sur Guide. Building a CustoMac Hackintosh: Buyer's Guide
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |